AV-GAD AV-702 Especificaciones descargar pdf (Pagina 22)

Testing Your System

It is recommended to test your system weekly. Perform system tests

in the off-peak hours, such as early morning or late evening. Call to

inform your monitoring station that you are testing your system.

Siren and Battery Test

Hold-down ‘1’ key. This command will generate a siren sound for 2-3 seconds.

Turn off your main AC, verify that LEDs are blinking to indicate power failure; test

siren again to make sure your battery can drive the siren during power failure.

Arm and Disarm the system (main AC is still off) few times, if ‘L’ is displayed, your

battery is faulty, call your installer.

Detection Devices Test

Test

Key 7

Î FAULT FIND

Fault Find enables testing of all detection devices.

Fault Find mode can be entered only during the 15 seconds following system

Disarming.

Fire, 24H, or Panic alarm will stop Fault Find mode.

Hold down ‘7’ key, confirmed by ‘F’ on Keypad display.

Activate each sensor. Detection of zone opening is confirmed by a one-second beep.

Three beeps indicate zone closing.

Arm the system to quit Fault Find mode.

Testing your Central Station (CS)

Inform your CS that you perform testing, ask them to report you if an alarm is

received. Arm the system, move in front of a detector or open a protected door, verify

that the siren is activated; to quit testing, disarm the system.

Test your system once a week.

Call your installer if any test fails to operate

1 2 ... 17 18 19 20 21 22 23 24

Sin comentarios

AV-GAD AV-702 Especificaciones Pagina 22