AV-GAD AV-702 Especificaciones descargar pdf (Pagina 14)

c Chime

Confirms Chime mode via ‘5’ key

c Closing

When events log is displayed Indicates Arming followed by

user number

d Delay Delete

Confirms Delay Delete Upon holding-down ‘4’ key

P Dial Delay

When programming telephone number that requires an inter-

digit delay (‘Pause‘) during dialing. (Delay duration is 2

seconds.)

E Error

Indicates programming and operation error

h Home

Indicates entering of Home Mode (Group Bypass)

h Hour

Displayed after power-up to remind user to set the system

time: ‘h’ will be removed after time setting (using keys 0

and 1).

H Hold-Up

Upon Panic triggering from Keypad

o Opening

Indicates system opening (Disarming). Followed by user

number when events log is displayed

L Low Battery

Indicates Low Battery – Call your installer

P Program

System is in programming mode

t Tamper

Indicates zone's Tamper alarm

U Update

Confirms programming updating

u User

‘u’ (user) followed by user number when events log is

displayed and system is in user code programming mode

{

(Three lines)

Arming Denied

AC Failure

event

{

Displayed upon Arming attempt with non-delayed

(instant) zones in trouble.

{

Displayed after AC failure, in history display at the AV-

701 keypad, indicating the power-fail event

Setting New Code for the AV-701

1. Hold down key

Program

2. While four LEDs are blinking, enter the master code (default 1234)

3. If code is valid, four LEDs will stop blinking, and ‘u’ will be displayed

4. The two Left-Most LEDs blink to indicate that the system is waiting for a new user

code index (user 1 to 8) to be entered

5. Enter the code index (1 for code No. 1; 2 for code No. 2, etc.). User index will be

displayed for 2 seconds, until further digits are entered (eliminate confusing of

index number and code)

6. The two right-most LEDs blink to indicate that the system is waiting for a new

code (1 to 6 digits) to be entered.

If user code is not entered, the code is voided

7. Enter the new code; ‘U’ is displayed for confirmation

8. To quit code setting, hold-down ‘9’

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comentarios a estos manuales

Sin comentarios

AV-GAD AV-702 Especificaciones Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad AV-GAD AV-702