10
Note: The instant arming is not recommended. This will allow the
easy arming by someone who is not a regular user.
Auto Arming
Auto Arming provides setting of the desired system arming time when the regular
user is away. This feature is useful for shop and sites requiring long exit delay.
Enter to user programming mode; hold-down ‘8’ key then enter your master code,
three LEDs are blinking.
Hold down '8' ('A' is displayed); type hour and minutes in 24 hours format.
To display, hold down '8' and wait. To disable Automatic Arming program 0000.
After Automatic Arming is programmed, the system time can be set only via User
Programming Mode: Enter User Programming Mode (hold-down ‘8’ and 1234), hold
down '1' ('t' is displayed) and type hour and minutes. Hold down '1' and wait for the
time to be displayed. Holding down '0'+'1' keys to program the time is possible only if
the Automatic Arming is disabled (otherwise an 'Error’ warning is displayed).
Automatic Arming will not operate if the system time has not been set (blinking 'h').
Automatic Arming will not operate if the control panel is already armed.
Automatic Arming will operate even if the control panel is currently in ALARM.
When the Automatic Arming programmed time arrives, the system starts at a
30-second countdown. An 'A' is intermittently displayed and beep sounds at keypad.
During the countdown period, the Automatic Arming can be aborted by entering a
valid user code (not code No. 7, if used to ‘open’ a door).
Remote Arming via Remote Key or DTMF
The Remote Arming allows you to use a remote key switch, or wireless tiny
transmitter to arm the system. This command is designed to arm the system without a
code, or for convenient arming from your car.
Remote functions with DTMF:
“D” suffix (D for DTMF) alarm panels type provides more remote functions:
The DTMF remote control functions:
Î
Check the control panel status (Armed/Disarm, Alarm in progress)
Î
Arm or disarm the control panel
Î
Bypass zones or clear all bypassed zones
Î
Stop the dialer report during alarm
Î
Momentary activate A1 (alarm) output for three seconds
To get on-line, dial to the control panel. The control panel will answer the call after
the number of rings (as programmed). When answering the call, the control panel
sends a greeting tune sound, during the next 5 seconds enter your user code (1234)
confirmed by # key.
(40 paginas)
(1 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales